Well the cross member is now completed. Over the
last weekend I finished up the few remaining jobs.....
A new cable route was made for the rear wiring
loom. I decided to keep it simple and just cut out a tab of metal to allow the
cable to run through. This was then filed and polished.
I then decided to modify the end of the QD tow bar.
After giving it some thought I wasn't happy with the quantity of metal left
holding the drop plate in place. So I cut down the profiled sides.
I then welded on some 8mm plate either side and
reformed the hole through for the hitch pin. The whole lot was then ground down
and polished up.
Every thing was fitted to ensure all was
OK.
It was then given a lick of under coat to protect
it from rust until it was time to carry out the painting.
On to the next lot of jobs......
No comments:
Post a Comment